iSpringRO600-BN 3-Stage Tankless Reverse Osmosis System, 600 GPD
Tankless reverse osmosis system rated at 600 GPD with a 2.5:1 pure-to-drain ratio, booster pump and twist-and-lock filters.
$449
We may earn a commission if you buy through this link. It never affects our scores. How this works
Usability
Usability
The RO600-BN is the value pick of iSpring's tankless range: it carries the same 2.5:1 pure-to-drain ratio as the RO800G for eighty dollars less, and beats the pricier RO500 line on efficiency outright. You give up output, dropping from 800 to 600 GPD, and you give up the NSF listing that the RO500 family carries. If certification is not your deciding factor, this is the most water you get per dollar. It is also the tankless model with the most retailer feedback behind it, though Home Depot serves one review file across the whole tankless range rather than one per model, so that feedback describes the platform and not this unit. Two cartridge types and twist-and-lock changes make it the easiest system in the line to live with. At 0.4 GPM it is slower at the tap than the RO800G despite the same drain ratio, which is the one place the saving shows.
- 2.5:1 pure-to-drain ratio, better than the more expensive RO500 line
- Cheapest tankless system iSpring sells at $448.99
- 600 GPD with a built-in booster pump handles low supply pressure
- Only two cartridge types to track, FCF600 and MRO600
- Filter-life indicators warn before a cartridge expires
- Automatic self-clean runs after 24 hours of non-use
- Twist-and-lock filters change without shutting off the water
- No published NSF/ANSI certification listing, unlike the RO500 family
- 0.4 GPM flow is slower than the RO800G despite the same drain ratio
- No remineralization stage, so the water tastes flat
- Requires an under-sink electrical outlet
- Municipal water only; well water needs pre-treatment
- Warranty is 1 year and requires product registration
The iSpring RO600-BN is a tankless reverse osmosis system rated at 600 gallons per day, sitting between the 500 GPD RO500 line and the 800 GPD RO800G. A built-in booster pump feeds an FCF600 composite pre-filter and a 600 GPD MRO600 membrane, filling an 8 oz cup in under 10 seconds at up to 0.4 GPM.
It runs a 2.5:1 pure-to-drain ratio, matching the RO800G and beating the 2:1 of the RO500 family. Filter-life indicators stay white in normal use, blink white below 10 percent remaining and turn red when replacement is due. An automatic self-clean cycle runs after 24 hours without use.
The body is BPA-free and the twist-and-lock cartridges change without shutting off the water supply. iSpring publishes no NSF/ANSI certification listing for the RO600-BN, unlike the RO500 line, so its contaminant figures are manufacturer specifications.
Additional information
Specification: iSpring RO600-BN 3-Stage Tankless Reverse Osmosis System, 600 GPD
| Water Filtration Specifications | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
||||||||||
| General Specifications | ||||||||||
|
||||||||||
Questions answered from our data

How long do iSpring filters last?Of the 24 iSpring systems we list, 24 state a filter life; the most common is 6-12 months (22).
How much does a reverse osmosis system cost?The 69 reverse osmosis systems we list run from $165 to $3,779, with a median of $367.
How long do reverse osmosis filters last?Of the 69 reverse osmosis systems we list, 64 state a filter life; the most common is 6-12 months (62).
Does reverse osmosis remove fluoride?63 of the 76 reverse osmosis systems we list claim to reduce fluoride.








