Vatrer 1000W 12V Pure Sine Wave Inverter
- 12 V system
- 1,000-1,499 W output
- 1-year warranty
A 1,000 W pure sine wave inverter for 12 V batteries, with an LCD fault display, temperature-controlled fans, a USB port and a 1 A no-load current.
$130
We may earn a commission if you buy through this link. It never affects our scores. How this works
Usability
2.6 out of 10Strengths
- Clean pure sine output
- High rated peak efficiency
- Fault codes shown on screen
- Fans stay off at light loads
- Works with lithium and lead-acid banks
Drawbacks
- No surge rating published
- Remote is an optionnot standard
- No transfer switchGFCI or eco mode
- Short warranty for an inverter
- Weight and size unpublished
Specs
- CapacityNot applicable
- AC Output1,000-1,499 W
- System Voltage12 V
- Panel PowerNot applicable
- Charge CurrentNot applicable
- Safety ListingNone verifiable
- Cell TypeNot applicable
- Low-Temp ChargingNot applicable
- Warranty1 Year
- MonitoringWired display or port only
Not published by Vatrer: weight.
At a glance
- 9.5-16.5 V DC input
- USB 5 V, 3.4 A
- THD 3% or less
- Dual cooling fans
- Vatrer Power is the brand of Shenzhen Vatrer Power Source Technology Co., Ltd., a company based in Shenzhen, China, that its own blog says was founded in 2021.
- The VATRER trademark is registered at the USPTO to Guangdong Zhongju Power Technology Co., Ltd. of Huizhou, and no US company is named behind the brand.
- It sells with a cart at vatrerpower.com, which also runs Canadian, European, Japanese and Australian stores.
- In the US it also sells on Amazon through the VATRER POWER brand store and on Walmart.com as the marketplace seller VATRER POWER.
The Vatrer 1000W (store SKU 1kw) is a 1,000 W pure sine wave inverter that turns a 12 V battery bank into 110 to 120 V AC within 5 percent, with harmonic distortion at or below 3 percent.
It runs on 9.5 to 16.5 V DC, alarms at 10 V, shuts down below 9.5 V or above 16.5 V, and works with LiFePO4, AGM, gel, flooded and sealed lead-acid batteries; Vatrer recommends at least a 12 V 100 Ah battery for full load. Vatrer's spec table and manual rate efficiency at 85 to 95 percent and no-load current at 1 A.
It has a USB output of 5 V at up to 3.4 A and an LCD showing input and output voltage, frequency and fault codes. Two cooling fans start only when the case reaches about 104°F or the load passes 40 percent of rating, and it shuts down at about 149°F.
It protects against under- and overvoltage, overload, short circuit, overheating and reverse polarity, works from 32 to 104°F, and takes an optional wired remote. Vatrer publishes no surge rating, weight or dimensions for it.
